Attwood SpringLift Series Gas Springs

It was an exact replacement for my old one - works great to keep my boat battery hatch open.

Nice product good price...they work fine but make sure to get the correct pressure rating or you can break the area it is attached to.

As stated in the instructions, the item is under load; Do not attempt to compress prior to installation!

Easy to use, just weighing the door to get pressure rating should work, but the 20 pound ones aren't even able to fully lift my 10lb aluminum utility body doors.

order early it took 13 days to get the order seems like a long time to me

This item was not shown in the catelog. I had purchased the wrong item, and the gentleman on the Jamestown tech line was most helpful in getting the proper item and with returning the incorrect ones I had previously ordered.

the product i used was very easy to install and the order process was very simple and quick

The Springlift shock replacements were fast and easy to install, the Boat lids were back to normal in no time.

The 55# rated Atwood gas springs for my engine/bilge hatch cover in my 1989 Bayliner Ciera Sunbridge were not doing the job to the point that as a safety measure I used a boat pole to ensure that the heavy cover would not come down on my head when I was working in there. Exact part replacements were no longer available. The O.A.L. of the old shock was 19-5/8"" so I hoped that the 20"" 60# shock (ATT SL34605) would be close enough to work. When I initially tried to install the new springs I could not push the stroke end down enough to pop it onto the 10mm ball (at least not without getting a finger pinched along the way) nor could I get the hatch to rise up to the 20"" O.A.L.when not under pressure. I had to think about it. A week later armed with a new 24"" clamp I compressed the gas spring the requisite amount and popped it on. The 2nd spring on the other side of the hatch went even quicker and in 10 minutes I was done. I was a little concerned that the new springs might be too powerful and the hatch would spring open, but that has not been the case. The hatch now opens easily and stays closed when down. I no longer have to be concerned about it whacking me in the noggin when I am working in there. I am very satisfied with these springs.

I needed new gas springs for my trucks utility bed box lids and these were the exact same spring. The springs worked perfectly.

Bought 2 for a small electronics box. Only used one, as it's more than adequate. Couldn't imagine 2 on this small a door. Shipping was timely.

Exact replacement for the rear hatch of my 23 yr old Ranger bass boat. The first one only lasted 22 years!

Use it to support a heavy engine hatch and a to lift a bench on my boat does both with ease.Exceeded my expectations.[...]

The Poeple here are great and easy to deal with, i would shop here again. thanks Ron